Pivot System Pricing

Specifications

• Pivot Point

  4 leg fully galvanized with 165mm OD supply riser, 90° inlet elbow and conductor slip ring, and tie down kit

• Spans

  Modified heavy duty Warren truss, overball connection with fabric reinforced 4 ply abrasion resistant rubber boot and ball valve drain

• Span Pipe

  165mm x 3mm galvanized pipe

• Pivot Trucks

  165mm x 3mm galvanized steel main frame

• Drive Motor

  1-1/2 HP 460V 1700 RPM @ 60 hz motor coupled to 50:1 helix gear reduction box

• Final Wheel Drive

  Single 50:1 worm gear design with expansion chamber

• Tires and Rims

  14.9" x 24" AG (new) on galvanized rims

• Finish

  Hot dipped galvanized minimum 3.15 mil thickness

• End Tower Speed

  Voltage	Power Cycle	Motor RPM	Approx. Ground Speed at 100% Timer Setting
  460V	60Hz	1700	8.8 feet/minute
  380V	50Hz	1400	7.25 feet/minute

Electronics

• Control Panel Enclosure (NEMA 4)
  1. Heavy Duty Disconnect Switch, Lockable
  2. Volt Meter
  3. Hour Meter
  4. Speed Control, Percent Timer
  5. End Tower Power Light Indicator
  6. System Start and Stop/Override Push Button Switch
  7. Forward/Reverse Switch
  8. Safety Circuit Light
  9. Control Power On/Off Switch
  10. Surge Suppressor
  11. End Gun Switch Only*
  12. Forward/Reverse Lights
  13. Auto Reverse Switch Only*
• End Tower HD Running Light
• Safety Lockout Hasp
• Dual Rod Grounding Kit
• 11-Conductor Collector Ring
• Stall Tower Box
• Intermediate Tower Box
• End Tower Box
• Span Cable, 11 Conductor Shielded Wires, Shielded Drain. 4 each 12 ga. and 7 each 16 ga. Copper Wires

*Note: Switch only, no mechanical components, see options.